How to use Henna

First, you need to know that dries within a few seconds on your skin , so it is better to use gloves during the preparation and clean after.

You have to protect with some paper the surface you will use to put the products on. Be careful with your clothes and also your clients clothes. It is also better to tie up long hair to avoid the contact with henna.

The client cannot move while you are tattooing. It is totally dry after 30 to 45 minutes. But it is preferable to wait 5 hours before taking off the film warm water. You will have to watch than nothing will touch the tattoo before it is dry.

The Henna I propose colours only the superficial part of the skin. If you want to take off your tattoo when it is close to the end, use a scrub soap.

When using henna powder, in the pipe mix 4 quantities of water for 1 of powder approximately.

Once the water is in the pipe, use something like a business card fold in two to poor the powder. Then mix with a stick until you get something homogeneous. Try it on you, if the mixture dribbles, add a bit of powder. If the mixture is too thick, add a very little of water with a needle in the pipe.

Once the mixture is ready, introduce the metal nib or tip, block it with your gloves and shake it for a few seconds.

A pipe is enough for about 30 tattoos. Before starting, always try it on you and never forget to wear gloves.

You can use henna after five minutes and for eight hours after the preparation is done. After that henna will not be as colourful. If you just want to do a few small coatings, mix less product. Once you finished, never forget to wash or rinse all your tools.

Contenu : poudre de henné.